Makita 440 Manual De Instrucciones página 19

3
.....
USING THE FOAM FILTER code 83035BHB (fi g. "B5")
- Release the motor unit to vacuum liquids (fi g. "A1").
- Place the foam fi lter on the motor housing (fi g. "B5").
4
..... USING THE POLYPROPYLENE BASKET PRE-FILTER code 83100BJA
(fi g. "B6")
Only use the basket pre-fi lter with the cartridge fi lter installed.
- The pre-fi lter can be used to vacuum fi ne dusts such as cement, plaster, sawdust
etc.
- Insert the ring of the polypropylene fi lter into the drum (fi g. "B6").
5
..... EXHAUST FILTERS code 83021B8X
- The exhaust fi lters ensure that the air blown back into the room is clean.
-------------------------------------------------------------------------
C - USING THE APPLIANCE
1
.... FOR USE AS A DRY VACUUM CLEANER
- The cartridge fi lter must always be used.
CAUTION: • The cartridge fi lter must be kept clean at all times for the appliance to
2
.... FOR USE AS A WET VACUUM CLEANER
- Remove the cartridge fi lter.
- Fit the foam fi lter as described in point "B5".
CAUTION: • When the vacuumed liquids reach the maximum level inside the drum,
- Switch off the appliance immediately and empty the drum.
3
.... TO VACUUM LARGE QUANTITIES OF LIQUID (fi g. "C1")
- When vacuuming liquids from containers, make sure the crevice tool is never fully
submerged to ensure partial air fl ow.
4
.... TO USE A POWER TOOL WITH THE VACUUM CLEANER
(fi g. "C2" - "C3" - "C4")
- The cartridge fi lter must always be used.
- Remove the foam fi lter if installed
work well.
suction is automatically shut off by the safety fl oat. The user is alerted by
the increase in the rpm rate of the motor and by the lack of suction.
(fi g. "B7")
.
- 19 -
EN