Assembling The Slide Rod (Only Mini2Go Deluxe Plus); Installing The Light (Only Mini2Go Deluxe Plus); Inside The Housing - Micro Mini2go Deluxe Manual Del Usuario

aSSembling the SliDe roD (only mini2go Deluxe PluS)

When removing, loosen the seat housing hooks on the underside of the deck carefully; otherwise,
they may break.
Assembling the slide rod (only Mini2go Deluxe Plus)
1. Lay out all the parts of the Mini2go Deluxe Plus in front of you (see Fig. M).
2. Insert the base slide rod
3. Remove the bulb socket pin
4. Attach the slide rod
5. Adjust the length of the slide rod so that the holes are exposed and attach the bulb socket pin (see Fig. Q).
6. Push the base locking mechanism
seat (see Fig. R).

Installing the light (only Mini2go Deluxe Plus)

Inside the housing

1. Hold the bulb in your hand and make sure that the arrow is pointing forwards before assem-
bling (see Fig. S).
2. Push the bulb into the opening (see Fig. T).
3. Twist the bulb in the opening until it locks into place (see Fig. U).
26
All manuals and user guides at all-guides.com
into the hole on the back side of the seat (see Fig. N).
15
(see Fig. O).
18
to the base slide rod (see Fig. P).
14
through the end of the slide rod on the underside of the
19