Power Supply - Grundig MC 9030 Manual Del Usuario

3 Power supply

3.1 Operating with the
power adapter
Check that the voltage indicated
on the rating plate of the power
adapter corresponds to your local
power supply.
The only way to disconnect the ap-
pliance from the power supply is to
unplug the power adapter.
1. Plug the charging plug into the
appliance socket and the power
adapter into the wall socket.
CAUTION!
A
groove on the charg-
ing plug must match
the notch in the ap-
pliance socket.
– LED battery symbol will start
flashing, when the batteries
are charged. Once the clipper
is completely charged, LED
battery symbol will illuminate
continually.
36 / EN
C
2. LED battery symbol will start
flashing when the unit reaches
low battery capacity during
operation.
– When the batteries are
discharged:
symbol will not display.
The
C
C
C
Hair and Beard Clipper / User Manual
Charging time:1.5
hours when the bat-
tery is fully charged
LED battery
Discharge the ap-
pliance through
normal use. Then
recharge to full ca-
pacity. Maximum
battery capacity will
only be reached af-
ter several charging/
discharging cycles.
The adapter and unit
may become warm
while charging; this
is normal operation.
When the appliance
is fully charged, it
has a cordless op-
erating time of up to
120 minutes.