Magnat BULLDOG 7 Notas Importantes Sobre La Instalación página 15

OPERATING ELEMENTS AND CONNECTIONS ON THE REAR PANEL
Power switch, charging switch, mains connection
Connect the supplied mains cable to the power socket.
The operating mode is selected via the POWER and CHARGE switches.
Mains cable
POWER CHARGE
OFF OFF
ON OFF
ON OFF
ON ON
ON ON
OFF ON
OFF ON
CAUTION:
The speaker should always be operated with the battery installed and connected. If it is necessary to operate the speaker without a battery,
both switches (POWER and CHARGE) must be set to "ON".
NOTE:
We recommend charging the battery on a regular basis, even when the speaker is not being used (once a month). Doing this will increase the
service life of the battery. The battery is only partially charged when delivered. Please fully charge the battery before using it for the first time.
Audio connections
Audio input for channel 1:
A mono audio source (microphone or guitar) can be connected to channel 1.
An XLR/6.3mm combi jack is available for this purpose.
110–240V~ 50/60Hz
FUSE: T 3.15 AL / 250V
POWER CONSUMPTION: 200W
connected
– The device is switched off, the battery is not being charged
no The device is switched on, battery operation
yes The device is switched on, mains operation
no The device is switched on, battery operation, the battery is not being charged
yes The device is switched on, mains operation, the battery is being charged
no The device is switched off, the battery is not being charged
yes The device is switched off, the battery is being charged
15