Magnat BULLDOG 7 Notas Importantes Sobre La Instalación página 17

Mixer channel 3:
This channel can be connected to a Bluetooth
source, or a mobile audio device can be connected
via a stereo cable with a 3.5mm jack plug (AUX IN
input socket).
CLIP LED (overload indicator):
The LED lights up red if the channel is overloaded.
Reduce the volume (VOLUME) or adjust the tone
control (reduce the bass and treble levels by using
the BASS and/or TREBLE controls).
BT/AUX:
This switch selects between the Bluetooth input and
the AUX input.
BASS, TREBLE:
These controls can be used to adjust the bass and
treble levels for channel 3 within a range of +/-8dB.
VOLUME:
This controller adjusts the volume of channel 3.
Master channel:
The audio signal from the 3-channel mixer is routed to the master channel. The following
setting options and functions are available here:
LIMIT/ON LED (overload indicator):
The LED lights up red if the power amplifiers are overloaded. Reduce the volume (MASTER)
or adjust the tone control (reduce the bass, midrange and treble levels by using the BASS,
MID and TREBLE controls).
CH1+CH2+CH3 IN/SECONDARY IN:
This switch is used to select between the normal operating mode (CH1+CH2+CH3
IN) and the PRIMARY/SECONDARY mode. When operating a single Bulldog 7 speaker,
this switch must be set to CH1+CH2+CH3 IN. The procedure for connecting a second
Bulldog 7 speaker is described in chapter PRIMARY/SECONDARY Operation on page 18.
BASS, MID, TREBLE:
These controls can be used to adjust the bass, midrange and treble levels for the master
channel within a range of +/-8dB.
MASTER:
This controller is used to adjust the overall output volume.
Monitor:
The Bulldog 7 is equipped with a monitor function. The audio signal of each individual mixer
channel can be previewed individually via headphones.
USB-CHARGE:
CH1/CH2/CH3:
HEADPHONES:
VOLUME:
Bluetooth pairing:
• Set the selector switch to BT.
• The speaker now automatically switches to its
pairing mode and the blue LED (PAIRING) flashes.
If not, please press the BT PAIR button briefly
• Now activate the Bluetooth mode on your source
device. The speaker will appear in the list of Bluetooth
devices as "Magnat Bulldog 7". If it is not displayed in
the list, set your source device to search for Bluetooth
devices manually and make sure that the speaker
has been switched to its pairing mode.
• When pairing is successful, the LED (PAIRING) will
display a solid blue light.
• The Bluetooth connection can be disconnected again
by pressing the BT-PAIR button.
• If you have previously connected a Bluetooth device,
the speaker will automatically attempt to re-establish
a connection with this device. If this is the case, you
may be required to manually reconfirm the connection
on the source device.
FADER (speaker balance control):
This controller can be used to fade between channel 1/2 and channel 3.
When set to the left position, only the signal from channel 1 and 2 (depending on the
setting of the respective channel volume) is routed to the master channel; when set
to the right position, only the signal from channel 3 is routed. When set to an area in
between, the channels are continuously mixed.
USB charging socket. External mobile devices (e.g. a smartphone or
tablet) can be charged via this socket (5V / max. 2A).
This switch selects one of the three channels to be listened to through
headphones.
Headphone socket for connecting headphones.
This controller adjusts the volume at the headphone jack.
17