Changing The Battery - Magnat BULLDOG 7 Notas Importantes Sobre La Instalación

CHANGING THE BATTERY

The battery is installed in a compartment at the rear of the speaker.
If it needs to be replaced, proceed as follows:
• Remove the battery compartment cover by loosening the four knurled screws.
• Remove the battery carefully and disconnect the cable connector by releasing the locking mechanism.
• The battery is inserted in reverse order.
PRIMARY/SECONDARY OPERATION - CONNECTING A SECOND BULLDOG 7
A second Bulldog 7 can be connected to provide sound for larger rooms.
In this setup, one Bulldog 7 is configured as the main speaker (primary) and the other as a so-called secondary speaker.
All audio sources, including Bluetooth, are connected to the main speaker. All of the settings for the mixer and master channel are also only
adjusted via the main speaker.
The secondary speaker is connected as follows using an XLR cable
MAIN SPEAKER
The selector switch for the master channel must be set to CH1+CH2+CH3 IN on the main speaker and to SECONDARY IN on the secondary
speaker. The control panel of the secondary speaker is then deactivated and the speaker reproduces the same audio signal at the same
volume as the main speaker.
NOTE: Both Bulldog 7 speakers reproduce audio in mono mode.
SECONDARY SPEAKER
18