Portable Air Conditioner Use - Hisense AP0819CR1W Instrucciones De Uso E Instalación

5
Insert the window exhaust adapter into the opening
in the vent panel.
Insert
Align the tabs on the
with the slots in the vent panel.
adapter
Insert the
window exhaust adapter
opening in the vent panel.
Operating your portable air conditioner properly helps you to
obtain the best possible results.
This section explains proper air conditioner operation.
IMPORTANT:
■ Do not stay in direct airflow from the air conditioner
for extended periods of time.
Never use in tightly enclosed spaces. Always ensure
■
there is sufficient airflow of outside air entering the
household especially when used in conjunction with
combustible devices such as gas stoves, fireplaces,
furnaces, hot water heaters etc. Do not place the
power cord or air conditioner near a heater, radiator,
stoves or other apparatus(including amplifiers) that
produce heat.
This air conditioner is intended for household use as
■
a residential appliance. Do not use it as a precision
climate control for commercial use, or for precision
equipment, food, pets, plants, artwork, etc.
Slot
window exhaust
into the

PORTABLE AIR CONDITIONER USE

Screw
Insert the screw in the hole in
the
window exhaust adapter
prevent the
window exhaust adapter
from sliding out of the vent opening.
■ Do not block or obstruct the exhaust vent hose as it
may severely affect performance, or cause failure of
the air conditioner.
■ The air conditioner display shows the current room
temperature.
■ When changing modes while the air conditioner is in
operation, the compressor will stop for 3 to 5 minutes
before restarting. If a button is pressed during this time,
the compressor will not restart for another 3 to 5 minutes.
■
In Cooling or Dry mode, the compressor and condenser
fan will stop when the room temperature reaches the
set temperature.
■
On Dry mode, the humidity level is automatically set,
but is not able to be displayed.
NOTE: In the event of a power failure, your air conditioner will
operate at the previous settings when the power is restored.
1 0
to