OPERATION
Moving Machine By Hand
When pushing or pulling the mower, engage the
bypass linkages with the hydro release levers.
The levers are located on each side of the rear of
the unit below the engine plate.
WARNING! Bypass linkages are
located close to the muffler. To prevent burns,
the engine should be shut off and allowed
to cool before the bypass linkage levels are
handled.
1. Raise the deck to the highest (transport)
position.
2. Pull the bypass linkages up and out of the
keyhole slots. Release the lever with the head
outside the bracket and held into the bypass
setting.
3. To reengage the hydro to drive, reverse the
procedure.
WARNING! Do not make adjustments
unless:
•
the engine stopped,
•
the ignition key removed,
•
the park brake activated
21