Zt-3100 Powertrain - Husqvarna Zero Turn Mower / MZ 61 Manual Del Operador

Ocultar thumbs Ver también para Zero Turn Mower / MZ 61:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTENANCE
Anti-scalp rollers can be set in three positions.
• Upper position 1" to 2-1/2" grass
• Middle position 2-1/2" to 4" grass
• Lower position 4" to 5" grass
The rollers must be approximately 1/4" from
ground. Do not adjust the rollers to support the
deck.

ZT-3100 Powertrain

Regular external maintenance of the ZT-3100
Powertrain™ should include the following:
1. Check oil level in expansion tanks. When
the engine is cold, the tanks should be at the
FULL COLD level.
2. Inspect the vehicle drive belt, idler pulley(s),
and idler spring(s). Insure that no belt slippage
can occur. Slippage can cause low input
speed to the transmission.
3. Inspect the transmission cooling fan
for broken or bent blades. Remove any
obstructions such as grass clippings, leaves
or dirt.
4. Inspect the park brake and vehicle linkage to
insure proper action and adjustment of the
parking.
5. Inspect the vehicle control linkage to the
directional control arm on the transaxle.
Also, make sure the control arm is securely
fastened to the trunnion arm of the transaxle.
6. Inspect the bypass mechanism on the
transaxle and unit linkage to make sure it
rotates and releases fully.
IMPORTANT INFORMATION Any servicing
dealer attempting a warranty repair must have
prior approval before conducting maintenance
of a Hydro-Gear® product, unless the servicing
dealer is a current Authorized Hydro-Gear
Service Center.
Cleaning
Regular cleaning and washing, especially under
the mower deck, will increase the machine's life-
span. Make it a habit to clean the machine directly
after use (after it is cooled), before the dirt sticks.
Do not spray water on the top of the mower deck.
Use compressed air to clean the top side of
mower deck. Regularly clean deck and underside
of the deck with normal water pressure. Do not
use a high pressure washer or steam cleaner.
Avoid spraying engine and electrical components
with water.
Do not rinse hot surfaces with cold water. Let unit
cool before washing.
CAUTION! Always wear eye
protection when cleaning and
washing.
Hardware
Check daily. Inspect the entire machine for loose
or missing hardware.
27

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido