Before Each Use; Pressure W Asher Maintenance - Snapper 580.752661 Manual Del Operador

OWNER'S RESPONSIBILITIES
Follow the hourly or calendar intervals, whichever occurs
first. More frequent service is required when operating in
adverse conditions noted below.
• Changeengine oil
• Check/clean water inlet screen'
• Check high pressure hose
• Check detergent siphoning hoses/tank
• Check spray gun and assembly for leaks
• Cleandebris
• Check engine oil level
:i I :i I :i I :i I :i I :i I :i I :i I :i I :i I :i I :i I :i I :i I :i I :i I :i I :i I :i I :i I
• Service engine air cleaner2
• Changeengine oil2
• Inspect muffler and spark arrester
• Service spark plug
• Cleancooling systeW
Clean if clogged. Replace if perforated or torn.
2 Service more often under dirty or dusty conditions.
General Recommendations
Regular maintenance will improve the performance and
extend the life of the pressure washer. See any Sears or
other qualified service dealer for service.
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence. To
receive full value from the warranty, the operator must
maintain pressure washer as instructed in this manual
including proper storage as detailed in Storage.
Some adjustments will need to be made periodically to
properly maintain your pressure washer.
All service and adjustments should be made at least once
each season. Follow the requirements in the Maintenance
Schedule chart above.
NOTICE Oncea year you should clean or replace the spark
plug and replace the air filter. A new spark plug and clean air
filter assure proper fuel-air mixture and help your engine run
better and last longer.
Pump Oil
DONOT attempt any oil maintenanceon this pump. The
pump is pre-lubricated and sealed from the factory, requiring
no additional maintenance for the life of the pump.
Emissions Control
Maintenance, replacement, or repair of the emissions
controldevices and systemsmay be performedby any non-
road engine repair establishmentor individual. However,
to obtain "no charge" emissions control service, the work
must be performed by a factory authorized dealer. Seethe
Emissions Warranty.
Before Each Use
1. Checkengine oil level.
2. Cleandebris.
3. Checkdetergent siphoning hoses/cleaning tank for
damage.
4. Checkwater inlet screen for damage.
5. Checkhigh pressure hose for leaks.
6. Checkspray gun for leaks.
7. Purge pump of air and contaminants.
PRESSURE W ASHER MAINTENANCE
Clean Debris
Daily or before use, clean accumulated debris from pressure
washer. Keeplinkage, spring and controls clean. Keep area
around and behind muffler free from any combustible debris.
Inspect cooling air slots and openings on the pressure
washer. These openings must be kept clean and
unobstructed.
Pressure washer parts should be kept clean to reduce the
risk of overheating and ignition of accumulated debris.
• Use a damp cloth to wipe exterior surfaces clean.
NOTICE Improper treatment of pressure washer can
damage it and shorten its life.
• DONOTinsertanyobjectsthroughcoolingslots.
• Use a soft bristle brush to loosen caked on dirt, oil, etc.
• Usea vacuumcleanerto pick up loosedirt and debris.
Check and Clean Inlet Screen
Examinegarden hose inlet screen. Cleanif it is clogged or
replace if it is torn.
16