Seat Adjustment Lever; Fuses; Cutting Height Pedal - RedMax CZT48x Manual Del Operador

CONTROLS

Seat Adjustment Lever

The seat can be adjusted lengthways with the
lever located at the right side of the seat (as
seen by the driver in the seat). When making
adjustments the lever is moved up.
Adjustments may be made to seat suspension by
turning the center knob.
IMPORTANT INFORMATION
be adjusted while the unit is in motion.

Fuses

Fuses are located on the right hand side of the
machine and are accessed by tilting the seat
forward. Fuses are flat pin fuses type as used in
automobiles. The 20 A is the primary fuse. The
7.5 A is for the mower deck coupling. The 10 A is
for accessories.
Seat should not

Cutting Height Pedal

The cutting height pedal lifts the deck to allow
setting the desired deck height. For transport,
push the lift pedal fully forward until the deck lift
latches in the transport (highest) position.
To set the deck cutting height, release the deck
height control by pushing forward on the pedal.
Rotate the cutting height pin 180
it and slip the pin into the hole for the desired
cutting height. The cutting height can be set from
1"- 5".
IMPORTANT INFORMATION Always raise the
deck to the highest position for transport.
O
to remove
15