Medisana 51085 Instrucciones De Manejo página 31

3.5 The MTX gives you the opportunity to assign readings to one of two user
Setting up the memories, each of which provides 99 memory slots. Switch the device to standby
user memory mode. Press the TIMER button
memory 2
3.6
With the MTX, you can choose between two measuring modes.
Selecting
the 3MAM
• Single reading
measuring • 3 consecutive readings ( Measurement Average Mode = 3/MAM-mode )
method
In the case of a single reading, just one blood pressure reading is taken and
stored.
The 3/MAM-mode is to be recommended if you suffer from severely
fluctuating blood pressure. 3 successive readings are taken at 15 second
intervals, thus eliminating widely varying readings. In the case of serious
deviations, a 4th reading may be taken.
From these three measurements, a weighted average value is calculated,
displayed and stored in the selected memory. A reading taken in this way is
indicated in the memory by an
The 3/MAM procedure greatly minimizes the risk of an incorrect reading.
1. To switch between single measurement and 3 consecutive measurements
2. Press the MEMO button
3. Confirm your selection by pressing the START button
NOTE
If you have correctly entered an alarm time and the alarm is
active, the alarm symbol
alarm is active for either of the user memories, no symbol
appears in standby mode.
.
(3MAM procedure), press and hold the TIMER button
for 3MAM mode
for the 3MAM measuring method and "
TIMER button to make the next setting: " Date time setting ").
3 Getting Started
appears in standby mode. If no
to select either user memory 1 or user
.
and " " appear flashing in the display.
to select either "
until the symbol
" or " "; "
" for single measurement.
(or press the
GB
"
25