Craftsman 580.325650 Manual Del Operador página 15

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

EHGINETECHNICALIHFORMATION
This is a single cylinder, overhead vaive(OHV), air coded
engine, it is a low emissions engine.
In the State of California, Model 200000 engines are certified
by the California Air Resources Board to meet emissions
standards for 250 hours. Such certification does not grant
the purchaser, owner or operator of this engine any
additional warranties with respectto the performance or
operational life of this engine. The engine is warranted solely
according to the product and emissions warranties stated
elsewhere in this manual.
Power Ratings
The gross power rating for individual gas engine models is
labeled in accordance with SAE (Society of Automotive
Engineers)code J1940 (Small Engine Power & Torque
Rating Procedure), and rating performance has been
obtained and corrected in accordancewith SAEJ1995
(Revision 2002-05). Torque values are derived at 3060 RPM;
horsepower values are derived at 3600 RPM. Actual gross
engine power will be lower and is affected by, among other
things, ambient operating conditions and engine-to-engine
variability. Given both the wide array of products on which
engines are placed and the variety of environmental issues
applicable to operating the equipment, the gas engine will not
develop the rated gross power when used in a given piece of
power equipment (actual "on-site" or net power). This
difference is due to a variety of factors including, but not
limited to, accessories (air cleaner, exhaust, charging,
cooling, carburetor, fuel pump, etc.), application limitations,
ambient operating conditions (temperature, humidity,
altitude), and engine-to-engine variability. Due to
manufacturing and capacity limitations, Briggs & Stratton
may substitute an engine of higher rated power for this
Series engine.
PRODUCTSPECIFICATIOHS
Generator Specifications
Wattage ........................
5600 Watts (5.6 kW)
Starting Wattage .................
8600 Watts (8.6 kW)
Rated AC Voltage ......................
120/240 Volts
Rated AC Current
at 240 Volts ........................
23.3 Amperes
at 120 Volts ........................
46.6 Amperes
Rated Frequency ...................
60 Hz at 3600 rpm
Phase ................................
Single Phase
FuelCapacity .........................
5 U.S. gallons
Unit Weight ...............................
170 Ibs.
Engine Specifications
Bore ..............................
3.12 in. (79 mm)
Stroke ............................
2.44 in. (62 mm)
Displacement ......................
18.64 in. (305 cc)
Spark Plug
Type: ....................
Briggs & Stratton 491055
Set Gap To: ...................
O.030inch (0.76mm)
Armature Air Gap: ........
0.008-0.012 in. (0.20-0.30mm)
Valve clearance with valve springs installed and piston 1/4 in.
(6 mm) past top dead center (check when engine is cold).
Intake .................
0.004-0.006 in. (0.10-0.15 mm)
Exhaust ...............
0.004-0.006 in. (0.10-0.15 mm)
Oil Capacity ...............................
28 fl. oz.
NOTE:For practical operation, the generator load should not
exceed 85% of rated wattage. Engine gross horsepower will
decrease3-1/2% for each 1,000 feet (300 meters) above sea
level and 1% for each 10° F (5.6° C) above 77° F (25° C). It
should operate satisfactorily at an angle up to 15° .
15

Publicidad

Tabla de contenido
loading

Tabla de contenido