LG W081CM TSB5 Manual De Usuario página 17

Install the Air Conditioner in the Case
1. Slide the air conditioner into the case.
Reinstall the 2 screws removed earlier on each
side of the case.
Screw
Power Cord
CAUTION: The power cord must be
connected to an independent circuit. The
green wire must be grounded.
2. Stuff the foam between the top of the unit and the
wall to prevent air and insects from getting into the
room.
3. Before installing the front grille, pull out the vent
control lever located above the unit control knobs,
as shown.
Use the Reversible Inlet Grille
1. If you want to pull out the filter upward, open the inlet grille slightly.
Turn inside out the front grille.
Disassemble the inlet grille from the front grille with separating the hinged part
by inserting a "—" type screw-driver tip.
Rotate the inlet grille 180 degrees and insert the hooks into the lower holes of
front grille.
Then, insert the filter
2. If you want to pull out the filter downward, use the reversible inlet grille without
change.(The grille is already assembled for that way.)
5. Attach the front grille to the case by inserting the
Screw
The Foam
6. Lift the inlet grill and secure the front grille with a
16
tabs on the grille into the slots on the front of the
case. Push the grille in until it snaps into place.
When you detach the front grille
from the case, push the grille to
your right side and pull it toward
you.
screw. Lower the inlet grille into place.