Panasonic VIERA TC-L42E5H Instrucciones De Operación página 36

Set all channels automatically [Auto Tuning]
Automatically retune all channels received in the area.
1
Start Auto Tuning
Example: Digital TV
Digital TV Auto Tuning
All digital TV tuning data will be erased
●
All the previous tuning settings are erased.
●
When the operation is completed, the channel at the lowest position will be displayed.
● Search begins in the order from the lower channels to the higher channels.
● If tuning has not been done completely
Set Digital TV channel manually [Manual Tuning]
Normally use [Auto Tuning] or [Update Channel List] to retune Digital TV channels.
If tuning has not been done completely or for adjusting the direction of the aerial or dish, use this function.
●
All channels found will be added to the Channel List.
Digital TV Manual Tuning
Frequency
Signal Quality
Signal Strength
No. Channel Name
Digital TV: 0
Set Analogue TV channel manually [Manual Tuning]
Analogue TV Manual Tuning
2
Fine Tuning
Manual Tuning 2
Colour System
Store
1
Select the channel position
3
Search
36
[Manual Tuning] (see below)
[CH21] MHz
474.00
0 10
0 10
Type New
[Fine Tuning]
CH 2 ● Use to make small adjustments to the tuning of an individual channel (affected by
weather conditions, etc.)
69
Auto
[Manual Tuning]
Set Analogue TV channel manually after Auto Tuning.
● Set [Colour System], and then perform this function. Normally set [Colour System] to
[Auto].
● If a VCR is connected only with the RF cable, select channel position [0].
2
Settings are made automatically
Example: Digital TV
Digital TV Auto Tuning
Scan CH 5
This will take about 3 minutes.
CH Channel Name Type
32 TV Fin land Digital TV
32 Boxer Navigator Digital TV
32 SVT HD Digital TV
Digital TV: 3
Searching
select frequency
select offset
start scan
2
Select the channel
4
Select [Store]
select
store
69
Quality
9
9
9