Usb Connection; Usb Keyboard - Panasonic VIERA TC-L42E5H Instrucciones De Operación

PC connection
A PC may be connected to this TV so that the PC screen is displayed and sound is heard from the TV.
● PC signals that can be inputted: Horizontal scanning frequency 31 to 69 kHz; vertical scanning frequency 59 to 86 Hz (more
than 1,024 signal lines could result in incorrect display of the image).
●
A PC adaptor is not necessary for the DOS/V-compliant D-sub 15-pin connector.
Note
●
Some PC models cannot be connected to this TV.
●
When using PC, set the colour display quality of PC to the highest position.
● For details of the applicable PC signals
● Maximum display resolution
Aspect
●
D-sub 15-pin connector signal

USB connection

●
It is recommended to connect the USB Flash Memory or Communication Camera to the TV's USB ports directly.
●
Some USB devices or USB HUB may not be used with this TV.
●
You cannot connect any devices by using USB card reader.
● You cannot use two or more same kind of USB devices simultaneously except USB Flash Memory.
● Additional information for USB devices may be on the following website. (English only)
http://panasonic.jp/support/global/cs/tv/
■

USB Keyboard

● The USB Keyboard requiring its driver is not supported.
● Characters may not be displayed correctly on the TV screen depending on the connected keyboard.
●
Some of the keys of USB keyboards may correspond to the operation of the remote control.
USB Keyboard

Enter
Backspace
Esc
0 - 9 / Character
F1
■
Gamepad
● Check the gamepads that have been tested for the performance with this TV at the following website. (English only)
http://panasonic.jp/support/global/cs/tv/
●
Some of the keys of gamepads correspond to the operation of the remote control.
Example:
1
Select Start
11 10 9 8
74
"Input signal that can be displayed" (p. 75)
4:3 1,440 × 1,080 pixels
16:9 1,920 × 1,080 pixels
Pin No. Signal Name
R
G
B
NC (not connected)
GND (Ground)
Remote Control
Cursor buttons
OK
RETURN
EXIT
Numeric buttons
GUIDE
2
1 Volume Up / Down
2 Channel Up / Down
3
4
3 GUIDE
5
4 OK
5 RETURN
6 INTERNET
7 6
Pin No. Signal Name
GND (Ground)
GND (Ground)
GND (Ground)
NC (not connected)
GND (Ground)
USB Keyboard
F2
F3
F4
F5 / F6
F7 / F8
F9 / F10 / F11 / F12
Remote Control
10
11
Pin No. Signal Name
NC (not connected)
NC (not connected)
HD
VD
NC (not connected)
Remote Control
VIERA TOOLS
MENU
INPUT (AV)
Channel Down / Up
Volume Down / Up
Coloured buttons
Remote Control
7 VIERA TOOLS
8 EXIT
9 INPUT (AV)
MENU
Cursor buttons