Makita XTR01 Manual De Instrucciones página 15

NOTE: The actual cut size on the workpiece is slightly
different from the templet. The difference is the dis-
tance (X) between the trimmer bit and the outside of
the templet guide. The distance (X) can be calculated
by using the following equation:
Distance (X) = (outside diameter of templet guide -
trimmer bit diameter) / 2
1
3
► 1 . Trimmer bit 2. Templet guide 3. Distance (X)
4. Outside diameter of templet guide
Using the trimmer guide
Optional accessory
The trimmer guide allows for trimming curved side like
veneers for furniture by moving the guide roller along
the side of the workpiece.
1. Loosen the clamp screw, then install the trimmer
guide on the trimmer base, and then tighten the clamp
screw.
2
4
► 1 . Clamp screw
2. Loosen the clamp screw and adjust the distance
between the trimmer bit and the trimmer guide by turn-
ing the adjusting screw (1 mm (3/64") per turn). At the
desired distance, tighten the clamp screw to secure the
trimmer guide.
1
► 1 . Adjusting screw 2. Clamp screw
3. Move the tool with the guide roller riding the side
of the workpiece.
1
► 1 . Workpiece 2. Bit 3. Guide roller
z
15 ENGLISH
1
2
2
3