Makita XTR01 Manual De Instrucciones página 8

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

1
2
► 1 . Stopper pole 2. Feed button
8.
To perform fine adjustment of the cutting depth,
turn the dial on the stopper pole so that it indicates "0".
1
► 1 . Dial
9.
Turn the head of the stopper pole to obtain the
desired depth. To increase the depth, turn the head
counterclockwise. To decrease the depth, turn the head
clockwise.
1
► 1 . Head of the stopper pole
10. Tighten the stopper pole fixing nut.
1
► 1 . Fixing nut
11. Release the fixing lever.
► 1 . Fixing lever
ASSEMBLY
CAUTION:
Always be sure that the tool is
switched off and the battery cartridge is removed
before carrying out any work on the tool.
Installing or removing trimmer bit
NOTICE:
Do not tighten the collet nut without
inserting the bit. The collet cone may break.
Insert the trimmer bit all the way into the collet cone.
Press the shaft lock and tighten the collet nut with the
wrench or tighten the collet nut securely with the two
wrenches. To remove the bit, follow the installation
procedure in reverse.
8 ENGLISH
1

Publicidad

Tabla de contenido
loading

Tabla de contenido