Scope Of Delivery; Intended Use; Installation And Connection - Pontec PondoAir Set 1800 Instrucciones De Uso

Scope of delivery

Quantity
 A
1 1
2 4
3 4
4 1
5 2
6 1
7 2
8 1

Intended use

PondoAir Set 1800, referred to as "unit", may only be used as specified in the following:
• For aeration and supplying oxygen to garden ponds.
• For use in water fountain systems and ponds.
• Operate in accordance with instructions.
During the winter months, the unit can be used to keep the surface of the pond free of ice and prevent the pond from
freezing up. Prerequisite for this is that the temperature does not go below the permissible minimum outside tempera-
ture for the unit.

Installation and connection

 B
• Push both clips over the hose adapter. Fit the hose adapter onto the air distributor and onto the air outlet on the unit.
Secure both connections with the clips.
 C
• Connect the aeration stones and the air distributor with air hoses.
– Shorten the air hoses to the desired length for the installation.
– Keep the air hoses as short as possible.
 D, E
• Install the unit in a stable, horizontal and flood-protected position.
– Install the unit above the level of the water otherwise it will be damaged by water flowing back.
– Ensure that the unit is installed with a safety distance of at least 2 m from the water.
• Position the aeration stones in the pond.
– Lay the air hose/air hoses well protected and without kinks, keeping them as short as possible.
Commissioning/start-up
Switching on: Connect the unit to the mains. The unit switches on immediately.
Switching off: Disconnect the unit from the mains.
Description
PondoAir 1800
Air hose
Aeration stone
Air distributor
Clip
Hose adapter
Replacement membrane
Operating instructions
- EN -
13