Medisana MC 815 Instrucciones De Manejo página 25

3.2
Use the buttons on control pad to operate the massage seat cover:
Operation
• Switch on the device by pressing On/Off button
illuminates.
• When the "Upper Back" massage button
next to the button illuminates and the Shiatsu massage heads
move from the "Park" position at the base of the backrest, up to the
shoulder area, massaging the back in a circular motion whilst doing
so. Once the uppermost position has been reached, the direction of
rotation of the massaging heads is reversed. The heads then travel
down to the centre of the back. Once the heads reach this point, the
direction of rotation is reversed again and then travel up the back
again. If you press button
switched off and the massage heads remain stationary in their cur-
rent position.
• If you press the "Lower Back" massage button
the button illuminates. The Shiatsu massage heads
down the lower half of the back in a circular motion. The reversal of
the direction of rotation takes place when the respective end posi-
tions are reached. Pressing button
off this function and the massage heads remain stationary in their
current position.
• If you press the "Full Back" massage button
dure is similar to pressing buttons
entire back.
• You can enhance the shiatsu massage at any time with a vibration
massage for your thighs by pressing the vibration massage button
q
• The vibration massage in the upper thigh area can also be operated
separately by pressing vibration massage button
LED "L" above the button lights up and both vibration massage mo-
tors are switched on. They begin with a gentle massage. Press but-
ton again and the vibration level increases (medium intensity mas-
sage LED "M"). Press button a third time and the maximum vibration
level (highest intensity massage, LED "H") is switched on. After but-
ton is pressed a fourth time, the vibration massage is switched off
and LED "H" above the button goes out.
• The heat function can be activated at any time with the shiatsu mas-
sage, during which the vibration massage can also be activated.
Press the heat button
.
The heat is radiated through the massage heads
button again to de-activate the heat function; the LED goes out.
9
during the massage, this function is
7
during the massage, switches
8
and
7
to activate the function; the LED lights up.
9
3 Operating
. The power LED
5
is pressed, the LED
7
, the LED next to
8
travel up and
3
the function proce-
6
, except that it is for the
8
. Level indicator
q
. Press the
3
GB
3
17