Publicidad
Idiomas disponibles
Idiomas disponibles
Features
Rear Panel
1. Media Panel: Controls for the Bluetooth, SD, USB,
and FM radio sources. The Media Panel Mode source
symbol will illuminate when that source is playing.
2. USB Port: Connect your USB flash drive to play music.
3. SD Card Slot: Insert your SD card here.
4. LED Display: Displays the media panel modes for
Bluetooth, FM radio, USB and Aux.
Note: The display comes with a plastic protector on it.
Remove this for optimal viewing.
5. Mic Input (1/4"/6.35 mm & XLR): Connect a dynamic
microphone to the 1/4" (6.35 mm) or XLR inputs.
Control the volume of the inputs using the Mic Input
Volume knobs.
6. Mic Input Volume: Turn this knob to adjust the input
volume of the mic input.
7. Aux Input (1/8"/3.5 mm): Connect a CD player, digital
media player, or other audio source to this 1/8" (3.5
mm) stereo auxiliary input. Control the volume using
the Aux Input Volume knob.
8. XLR Input (XLR): Connect a line-level mixer or musical
instrument to this XLR line-level input. Control the
volume using the Aux Input Volume knob. Use this line-
level input when linking together two Total PA Plus units.
9. RCA Inputs: Connect a CD player, digital media
player, mixer, or other media source to these inputs.
Control the volume using the Aux Input Volume knob.
10. Aux Input Volume: Turn this knob to adjust the input
volume of the Aux input, XLR input, and RCA inputs.
11. Mix Out (XLR): Connect this XLR output to another
active (powered) speaker. The level of the output is
controlled by the Mic Input Volume, Aux Input
Volume, and Master Volume.
12. High EQ: Increases or decreases the high (treble) frequencies for mic inputs, line input, and
media panel sources at a range between -12dB to + 12dB.
13. Low EQ: Increases or decreases the low (bass) frequencies for Mic Input, Line Input, and media
panel sources at a range between -12dB to + 12dB.
14. Power LED: Indicates whether Total PA Plus is powered on or off.
15. Clip LED: This LED will flash red if the signal from the inputs or media panel source is clipping. If
this happens, decrease the setting of the Mic Input Volume knob, Aux Input Volume knob, or
Master Volume knob.
4
1
4
3
iPA69
6
6
10
5
7
5
9
5
5
8
11
2
12
13
16
14 15
19
17
18
Publicidad
