use + and - to select the day, P1 shows in screen (The wake up time for the initial setting, the
FR
time shows "OFF". Press
, the time become
into next step - wake up time setting: the hour ash (use + and - to set(23-hours). Then press
ES
OK, it enters into next step - minutes setting: the minute icon
set minute(0-58 minutes). Then press OK, it enters into next step - temperature setting: setting
PT
temperature ashes 20 (default temperature setting is 20°C ), use + and - to set(selected
temperature range 5°C - 40°C). Press OK, it enters into next step - OFF time setting:
IT
the hour ash use + and - to set(23-hours). Then press OK, it enters into next step - minutes
setting: to minute setting, the minute icon
EL
minutes). Press OK to con rm and it automatically enter to next working period. In this cycle,
you can set 7 days on/o timer.
PL
The
will be displayed on the working status. If you want to turn o the weekly program,
press
to turn o ,and the
RU
Remark:
UA
1.
During the process of WEEKLY program setting, if you want to quick nish the setting, press
for 3 seconds to con rm and exit.
RO
2.
After complete all settings(14 working periods=7daysx2periods/day), if you want to
remove 1 period: go to this period, then press
3.
For the current day: Before P1 starts, P1 working period will on the screen; If P1 pass, P2
EN
working period will on the screen; If P2 pass, the timer symbol will show on the screen.
TOWEL HEATING:
1.
After switch on the machine, press
turn o .
2.
When the towel rack is turned on: if fold the towel rack, icon
stop towel heating; if unfold the towel rack, icon
with 45W.
3.
The towel rack heating function is independent, no link with the heating of machine. The
working period is 2hours.The towel will stop automatically in 2 hours if you don't turn it o
manually, and icon
disappear from the screen.
Note: The maximum weightbearing for towel should less than 2kg/bar(6 kg in total for 3
bars).
BODY SENSOR (ONLY work during weekly program)
Press
to turn on body sensor, the icon
and the icon
disappear on screen. The body sensor will only work during WEEKLY PROGRAM
MODE, not work during MANUAL MODE. When body sensor works, if nobody is detected within 15
minutes, it will turn o the machine automatically.
65
and can start to set ). Press OK, it enters
ashes. Use + and – to
ashes. Use + and – to set minute (0-59
screen will disappear.
, the time will change to "OFF".
once to turn on the towel rack, press
disappear at the screen, and
shows at the screen and it start to heat
ashes on the screen. Press again, it will turn o ,
4. FILTER CLEAN
Filter becomes dirty during use, or after 150 hours usage, the indication
ashes with sounds "BE, BE, BE...". Press OK, sounds stop while
the appliance o , then remove the lter on the back of the appliance. Clean the
lter directly under water. Do not use caustic or abrasive material during
cleaning, as this can damage the lter. Then, have the lter dried naturally.
The machine can't work until
Then reassemble the lter according to the reference line(see below drawing).
Push the lter to the end until it cannot move anymore.
NOTE: You can remove and reassemble the lter from left.
5. RECYCLING
one more to
BH-1701E
230-240 V~ 50 Hz
2000 W
IP24
disappear, which will take around 15 minutes.
This marking indicates that this product should not be disposed with other
household wastes throughout the EU. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, recycle it
responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the
retailer where the product was purchased. They can take this product for
environmental safe recycling.
FR
ES
PT
ash. Turn
IT
EL
PL
RU
UA
RO
EN
66