Bras Maestrale Extra Manual De Instrucciones página 10

EN GLIS H
M A E S T R A L E - E X T R A
5. 3. 1 DISASSEMBLY
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source by unplugging it.
1
Remove cover from the bowl.
2
Remove the empty bowl by lifting first its front side (faucet
side) up and off bowl gasket (see figure 2).
figure 2
3
Remove the bowl gasket.
4
Remove the pump impeller from its location.
5
Pinch tube faucet: push the dispensing handle (1) and
take the pinch tube off from its seat (2) (see figure 3).
figure 3
6
Gravity faucet: extract the piston and then remove the
dispensing handle (see figure 4).
figure 4
7
Slide drip tray out and empty it.
All manuals and user guides at all-guides.com
5. 3. 2 CLEANING
1
warm (45-60 °C 120-140 °F) potable water and dishwashing
detergent. Do not use abrasive detergent.
Important: if present, follow label directions, as too strong a
solution can cause parts damage, while too mild a solution will
not provide adequate cleaning.
2
disassembled parts in the cleaning solution.
3
apart with the cleaning solution. Carefully clean their
undersides.
4
a soft bristle brush.
5
5. 3. 3 SANITIZING
Sanitizing should be performed immediately prior to
starting the machine. Do not allow the unit to sit for
extended periods of time after sanitization.
1
2
140 °F) sanitizing solution (100 PPM available chlorine
concentration or 1 spoon of sodium hypoclorite diluted with two
litres of water) according to your local Health Codes and
manufacturer's specifications.
3
4
wash their undersides with the sanitizing solution.
5
6
abrasive cleaner.
5. 3. 4 ASSEMBLY
1
2
insert the pinch tube into its vertical seat in the bowl bottom(2).
Lightly pull the pinch tube end downwards til itl is well arranged
10
ATTENTION
Before any disassembly and/or cleaning procedure make
sure that the dispenser is disconnected from its power
source.
Prepare at least two gallons of a mild cleaning solution of
IMPORTANT
In order to prevent any damages to the dispenser use
only a detergent suitable with plastics parts.
Using a brush, suitable for the purpose, thoroughly clean all
ATTENTION
When cleaning the machine, do not allow excessive
amounts of water around the electrically operated com-
ponents of the unit. Electrical shock or damage to the
machine may result.
Do not immerse the lighted top covers in liquid. Wash them
In the same manner clean the evaporator cylinder(s) using
Rinse all cleaned parts with cool clean water.
Wash hands with a suitable antibacterial soap.
Prepare at least two gallons of a warm (45-60 °C 120-
Place the parts in the sanitizing solution for five minutes.
Do not immerse the lighted top covers in liquid. Carefully
Place the sanitized parts on a clean dry surface to air dry.
Wipe clean all exterior surfaces of the unit. Do not use
Slide the drip tray into place.
Pinch tube faucet: push the dispensing handle (1) and