Operating Procedures; Operation Helpful Hints; Cleaning And Sanitizing Procedures; Description Of Controls - Bras Maestrale Extra Manual De Instrucciones

6
Do not put objects or fingers in panels louvers and faucet
outlet.
7
Do not remove bowls, augers and panels for cleaning or
routine maintenance unless the dispenser is disconnected from
its power source.
ATTENTION
In case of damages, the power cord must be replaced by
qualified personnel only in order to prevent any shock
hazard.
8
This unit is not meant to be used outside.
9
This unit is not to be installed in areas subject to water-
spouts..
10
Do not use water-jets to clean the unit.
11
This unit can work in a room temperature range between
+5° and +32°C.

5 OPERATING PROCEDURES

1
Clean and sanitize the unit according to the instructions in
this manual. See chapter 5.3 CLEANING AND SANITIZING
PROCEDURES.
2
Fill the bowls with product to the maximum level mark. Do
not overfill.
The exact quantity of product (expressed as liters and gallons)
is shown by marks on the bowl.
3
In case of products to be diluted with water, potable water,
pour water into bowl first, then add correct quantity of product.
In case of natural squashes, it is advisable to strain them, in
order to prevent pulps from obstructing the faucet outlet.
4
Install the covers and check that they are correctly placed
over the bowls.
5
Set the control switches

5.1 DESCRIPTION OF CONTROLS.

6
The dispenser must always run with the covers installed to
prevent a possible contamination of the product.
7
Always leave the dispenser on, as the refrigeration stops
automatically when the beverage reaches the dispensing
temperature. The mixing devices will continue to turn.
8
To maintain a high standard of flavour, keep refrigeration
and mixing devices on during the night when beverage is in the
bowl.
IMPORTANT
Operate the dispenser with food products only.
IMPORTANT
This appliance is not intended for use by person (inclu-
ding children) with reduced physical sensory or mental
capabilities, or lack of experience and knowledge unless
they have been given supervision or instruction concer-
ning use of the appliance by a person responsible for
their safety.
Children should be supervised to ensure that they do not
play with the appliance.
5. 1 DESCRIPTION OF CONTROLS
The dispenser is equipped with a power switch and each bowl is
operated by a mixing device switch (pump switch for BS lines,
mixer switch for AB - BS2M line).
Their functions are as follows:
All manuals and user guides at all-guides.com
as shown in chapter
9
Power switch
0 position
I position
Mixing device switch
0 position
I position
To operate the dispenser
1
Set power switch to I position.
2
Set mixing device switch(es) to I position.

5. 2 OPERATION HELPFUL HINTS

1
The length of time for cooling down the product is governed
by many variables, such as ambient temperature and beverage
initial temperature.
2
To shorten product cooling down time and increase
productivity, it is advisable to pre-chill the product to be used in
the dispenser.
3
To shorten product cooling down time and increase
productivity, the bowl should be refilled after the product level
drops lower than half and at the start of each day.
4
The dispenser must be able to emit heat.
In case it seems excessive, check that no heating source is
close to the unit and air flow through the slotted panels is not
obstructed by wall or boxes. Allow at least 15 cm (6") of free
clearance all around the dispenser.
In any case if the product in the bowls is cold the unit is running
properly.
5
How to reset beverage temperature:to reset beverage
temperature please apply to a technician.
The proper temperature is preset at the factory.
5. 3 CLEANING AND SANITIZING
PROCEDURES
Cleaning and sanitizing of the dispenser are recommended to
guarantee the conservation of the best product taste and the
highest unit efficiency. This section is a procedural guideline
only and is subject to the requirements of the local Health
Authorities. Prior to the disassembly and cleaning, the machine
must be emptied of product.
: power is turned OFF to all
functions.
This position operates the
fan motor and makes the
: mixing devices suitable to
be turned on by relevant
switches.
: OFF.
: mixing device runs.