Ryobi P4360 Manual Del Operador página 71

WARNING:
Do not allow familiarity with this product to
make you careless. Remember that a careless
fraction of a second is sufficient to inflict seri-
ous injury.
WARNING:
Always wear eye protection with side shields
marked to comply with ANSI Z87.1, along with
hearing and head protection. Failure to do so
could result in objects being thrown into your
eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
product. The use of attachments or accessories
not recommended can result in serious personal
injury.
WARNING:
Never fell a tree or cut a log or limb that has a
diameter greater that the length of the guide
bar. Only properly trained professionals should
perform these cuts. Performing these types of
cuts can cause an accident and result in death
or serious personal injury.
NOTICE:
Before each use, inspect the entire product
for damaged, missing, or loose parts such as
screws, nuts, bolts, caps, etc. Tighten securely
all fasteners and caps and do not operate this
product until all missing or damaged parts are
replaced. Please contact customer service or
an authorized service center for assistance.
APPLICATIONS
You may use this product for the following purposes:
 Limbing and pruning branches from trees
 Felling small trees
 Bucking the fallen tree into shorter lengths
OPERATION
This product will accept Ryobi One+ 18 V lithium-
ion battery packs and Ryobi One+ 18 V nickel-
cadmium battery packs.
For complete charging instructions, refer to the
Operator's Manual for your Ryobi One+ battery
pack and charger models.
TO INSTALL / REMOVE BATTERY PACK
See Figure 5.
WARNING:
Always remove battery pack from your tool
when you are assembling parts, making adjust-
ments, cleaning, carrying, transporting or when
not in use. Removing battery pack will prevent
accidental starting that could cause serious
personal injury.
NOTE: To avoid serious personal injury, always
remove the battery pack and keep hands clear of
the look-out button when carrying or transporting
the tool.
To install:
 Place the battery pack in your chain saw. Align
raised rib on battery pack with groove in chain
saw's battery port.
 Make sure the latches on each side of the bat-
tery pack snap in place and that battery pack is
secured in chain saw before beginning operation.
To remove:
Locate latches on side of battery pack and depress
both sides to release the battery pack from the
chain saw.
BATTERY
PORT
15 - English
BATTERY
PACK
LATCHES
Fig. 5