Safety Thermostat; Correct Product Disposal - Bezzera BZ13 CREMA Manual De Instrucciones

MOD. BEZZERA BZ13 - CREMA
drain basin.
Use water and neutral detergents to clean the tank
after removing it. When finished rinse thoroughly.
Replace the tank and insert the silicon tubes making
sure that the suction pipe touches the bottom.

6.3 Safety thermostat

Warning! The operation de-
scribed below is only relevant
to an installing technician who
is authorised by the manufac-
turer.
When the machine is on, if the boiler's resistor
over heats, the safety thermostat will be enabled,
which will interrupt the power supply, thus prevent-
ing greater damages to the machine. To restore
regular functioning, the failure that caused the
enabling of the safety thermostat must be solved
and the normal status must be reset by pressing
the red key (RESET) (Fig. 08).

6.4 Correct product disposal

(electrical and electronic waste)
(Applicable in the European Union countries and
those countries with separate waste collection
systems).
The sign carried on the product or on its
documentation
product must not be disposed of with
other domestic waste at the end of its
life cycle. To avoid any damage to the environment
or to health, caused by unsuitable waste disposal,
the user is asked to separate this product from
other types of waste and to recycle it responsibly to
help the sustainable recycling of material
resources.
Domestic users are invited to contact the dealer
where the product was purchased or the local
office in charge of this matter for all the information
relating to separate waste collection and recycling
for this type of product.
Company users are invited to contact their own
supplier to check the terms and conditions of the
purchase contract.
This product must not be disposed of together with
other commercial waste.
indicates that the
30