Replacing Carbon Brushes - Makita 4334D Manual De Instrucciones

3. Rotate the blade installing lever in the (4) direction
until it stops. The clamp will protrude from the blade
holder.
2
4. Remove the clamp from the blade holder while
rotating the clamp in the (5) direction.
1
2
(5)
Installing clamp
1. Make sure that the blade installing lever has been
rotated in the (4) direction until it stops.
(4)
2. Insert the clamp into the blade holder while rotating
it in the (6) direction one quarter to one full turn so
that its slot will face forward.
1
2
002993
1. Blade holder
1
2. Clamp
002781
1. Blade holder
2. Clamp
002782
002783
1. Blade holder
2. Clamp
(6)
CAUTION:
• Do not rotate the clamp more than one full turn
when inserting in into the blade holder. If you do so,
the blade may not be tightened firmly.
3. Grasp the clamp with your fingers so that it will not
turn, then rotate the blade installing lever in the (7)
direction until it stops. The clamp will go in the
blade holder.
1
(7)

Replacing carbon brushes

Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
10
002784
1. Blade installing
lever
001145
1. Limit mark
1
002786
1. Brush holder
cap
2. Screwdriver
1
2