Changing/Repositioning The Pump Oil; Cleaning And Storage; Environment Safety; Customer Service - VITO PRO-POWER VIML180WR4 Manual De Instrucciones

EN
It is important that the sprinkler
nozzles are regularly inspected
and cleaned.
5.3-CHANGING /
REPOSITIONING THE PUMP
OIL
The pump was dimensioned to run
with the same oil during the machine's
service life.
However, in case of leak, stop the
machine immediately and call technical
assistance.

5.4 - CLEANING AND STORAGE

Cleaning
Clean the machine after each use.
Careful handling protects the machine
and extends its lifespan.
Storage
The machine should be stored in a dry
place, mainly in the winter, to avoid
damages caused by the ice.
Problem - Cause
The tool does not start:
� The power cable is not plugged in or there is an
electrical failure;
� The extension cord is too long or the cord is to
thin;
� The power supply is to low;
� The system is pressurized;
� The thermal protection has triggered;
The machine is on but the water is not
running out:
� The tap is closed;
� The water inlet filter is clogged;
� The lance or the sprinkler nozzle are clogged;
34
1. After finishing, remove the water from
the pump, press the gun trigger until
there's no water in the sprinkler nozzle;
2. Disassemble the pressure hose, gun
and lances;
3. Drain the water from every accessory
and use a clean cloth to clean the hoses
and accessories exterior;
4. Clean the water inlet filter and the
sprinkler nozzle;
5. Put the cover in the water inlet;
6. Store the machine in a clean and dry
place;
6. ENVIRONMENT
SAFETY
The packaging is made up of
recyclable materials that shall
be disposed through local recycling
points.

8.FAQS / TROUBLESHOOTING

Solution
� Check the plug, socket and the circuit breaker of the power
supply circuit;
� Remove or replace the extension cord.
Connect the power cable directly in the electrical outlet;
� Check if the supply tension is the recommended;
� Press the gun trigger;
� Allow the machine to cool down and turn it back on;
� Open the tap;
� Clean the water inlet filter;
� Clean the lance and/or the sprinkler nozzle;
Never put this type of
machine in the domestic
waste.
According to the European Directive
2012/19/EC on electrical
electronic equipments waste, and its
transposition into national law, every
used electrical machines must be
collected separately and delivered to
the collection sites provided for this
purpose.
You can obtain information about the
disposal of old devices through the
legal responsible for recycling in your
city.

7. CUSTOMER SERVICE

Tel.: 256 331 080
E-mail: sat@centrallobao.pt
Site: www.centrallobao.pt
and