Publicidad
Wood Stud Installation
e
Using the wall plate keyholes, hang the lift assembly on the wall
screws.
f
PN: 888-61-053-W-02 revC
Install and tighten bottom two wall screws and securely
tighten top screws. Be sure that the lift engine is level before
tightening.
DO NOT OVER TIGHTEN.
CAUTION: When mounting to wood frame wall, one set of
mounting holes must be located in the center of a wood stud
no smaller than 2x4 inches (nominal). If in doubt, consult a
local construction expert. Failure to heed this caution may
result in equipment damage and personal injury
9
Publicidad
