Maintenance; Replacing Disposable Odor Fighting Hepa Inner Bag; Replacing Worn Belt; Replacing Brushroll - Oreck Aviator Upright Serie Guía De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Maintenance

E

Replacing Disposable Odor Fighting HEPA Inner Bag

WARNING: Unplug cord from electrical outlet before servicing.
BAG REMOVAL:
8
Unzip outer bag completely.
9
Pull bag cardboard collar to release bag dock door from connector. Bag dock door will hinge downward.
Gently pull bag cardboard collar upward out of the bag dock. Saniseal
10
BAG INSTALLATION:
Slide the cardboard collar completely onto bag dock door.
11
Firmly push bag dock door with both thumbs on indication point until it snaps.
12

Replacing Worn Belt

WARNING: Unplug cord from electrical outlet before servicing.
13
Remove the replacement belt from the storage channel.
14
Remove the door by removing the hold down screw located on side of power head.
15
Fold door away from the power head and lift it away.
16
Remove the belt from the motor drive shaft and brush roll pulley.
Loop the new belt over the brush roll pulley. Place the opposite end of the belt on the motor drive shaft.
17
18
Replace the door by placing the bottom tab on door into slots located inside power head and pressing the
door closed.
19
Replace the hold down screw and tighten.
13
14

Replacing Brushroll

WARNING: Unplug cord from electrical outlet before servicing.
Your Oreck Vacuum has a brushroll that can be replaced after heavy use for improved performance.
20
Remove the baseplate by removing 5 screws. Then, remove the belt and brushroll from the housing.
Snap the new brushroll into place.
21
22
Reassemble the belt.
Reassemble the baseplate.
23
20
6
N
G
L
I
S
H
8
9
19
15
21
®
dust seal will close automatically.
ENFONCEZ JUSQU'À
ENTENDRE UN BRUIT
PRESIONE HASTA
ESCUCHAR UN
CHASQUIDO DE SUJECIÓN
10
11
16
17
22
12
18
23

Publicidad

Tabla de contenido
loading

Tabla de contenido