Basic Properties - Velleman CAMIP5N Manual Del Usuario

Cameras are found but are not on the same subnet as the PC. The message Subnet doesn't match,
o
dbclick to change appears. Change the subnet settings via the network configuration menu (see
further).
Note: make sure DHCP is enabled in the router and MAC address filter is disabled. When problems remain,
disable any active firewall or antivirus and try again.
Windows:
Mac:
2. Open the options menu by right-clicking a listed camera.
Note: only when the camera is fully initialised all options become visible.

Basic properties

Shows some general information about the camera:
V. 02 – 22/05/2012
CAMIP5N
6 ©Velleman nv