Software Set-Up; Ip Camera Tool - Velleman CAMIP5N Manual Del Usuario

2. Follow the instructions on the screen. Click Next to start the software installation.
3. Click Next again.
4. To finish software installation, the computer must be restarted. Select Yes I want to restart my
computer now and click Close.
After rebooting, the IP Camera Tool icon appears on the desktop.
Mac
1. Locate and open the folder "For Mac".
2. Open the folder "IP camera Tool" and copy the tool to your Mac to use it.
8.

Software set-up

Make sure all connections are properly made (see also §6) and double-click the IP Camera Tool icon to start
the software.
8.1

IP Camera Tool

1. The software starts searching for cameras over the LAN. Three situations can occur:
No cameras are found on the LAN. If after 1 minute the software does not detect any cameras, check all
o
cabling of the system and make sure the camera is powered.
Cameras are found and listed (see image below).
o
V. 02 – 22/05/2012
CAMIP5N
5 ©Velleman nv