Fox F28-191A Manual De Instrucciones página 37

IV. Speed adjustment FIG.5-10
By moving the belt on the engine and flywheel pulleys you can use the bandsaw at two different speeds.
Inside the lower door there are some instructions explaining how to place the belt to obtain two different speeds.
1. Open the lower door with a screwdriver.
2. Loosen the belt by turning the tensioning knob clockwise.
Move the belt on the desired position, tighten the belt again and close the lower door by using a screwdriver.
- SMALL ENGINE PULLEY – LARGE FLYWHEEL PULLEY: blade speed 360 m/min, suitable for hard wood
types, plastics.
- LARGE ENGINE PULLEY – SMALL FLYWHEEL PULLEY: blade speed 720 m/min for all soft wood types.
Caution!
Do not place the belt obliquely, since it would suffer damages.
V. Knob for the adjustment of driving belt FiG.5
By using the adjustment knob (30) you can adjust driving belt tensioning:
- Turn the adjustment knob clockwise to reduce tensioning.
- Turn the adjustment knob anti clockwise to increase tensioning.
-
VI. Adjustment of workbench's inclination FIG.2
The workbench can be moved from 0 and 45°. To move it, loosen the lock screw (37), move the workbench to the
desired angle and tighten the screw (37).
VII. Rip fence FIG.4
The rip fence (33) can be assembled both on the left and on the right of the saw blade. Choose the position by using
a graduated scale, place the guide and lock it by lowering the front lever A.
EN
31