Maintenance And Care; Troubleshooting - Kärcher K 2 Full Control Manual Del Usuario

Maintenance and care

The appliance is maintenance free.
DANGER
Risk of electric shock.
 Prior to all work on the appliance,
switch off the appliance and pull the
power plug.
Clean the sieve in the water connection
Clean the sieve in the water connection
regularly.
ATTENTION
The sieve must not be damaged.
 Remove coupling from the water con-
nection.
Illustration
 Pull the sieve out (e.g. using flat pliers),
clean under running water and then re-
insert it.

Troubleshooting

DANGER
Risk of electric shock.
 Prior to all work on the appliance,
switch off the appliance and pull the
power plug.
Appliance is not running
 Push the lever of the trigger gun, the de-
vice will switch on.
 Check whether the voltage indicated on
the type plate corresponds to the volt-
age of the mains supply.
 Check the mains connection cable for
damages.
20 English
Care
Pressure does not build up in the
appliance
 Check setting at the spray lance.
 Completely open the water tap.
 Remove air from appliance before oper-
ation.
Switch on the appliance without con-
nection the HP hose (max. 2 minutes)
and run it until the water discharging
from the HP outlet is free of bubbles.
Switch off appliance and reconnect HP
hose.
 Pull out the sieve in the water connec-
tion using flat-nose pliers and clean un-
der running water.
Strong pressure fluctuations
 Clean high-pressure nozzle: Remove
dirt and debris from the nozzle bore, us-
ing a needle and rinse through with wa-
ter from the front.
 Check water flow quantity.
Appliance is leaking
 Slight leakage from the appliance pump
is normal. If the leakage increases con-
tact the authorized customer service.
No detergent infeed
 Use Vario Power spray lance.
Turn the spray lance to "Mix" position.
 Remove filter from suction hose for de-
tergent and clean under running water.
 Check the detergent suction hose for
kinks.