GYS AUTOPULSE 320-T3 Manual Del Usuario página 31

Process : corresponds to the interface of the welding process in progress:
Process parameter: allows process settings,
1
2
At the various adjustment windows,
2
JOB: gives access to the different JOB reminder modes.
3
Process parameters: corresponds to the process parameter setting window:
• MIG-MAG (GMAW): Material/gas pair (Synergic welding parameters), wire diameter,
welding process (Manual, Dynamic STD, etc.), trigger mode.
3
Energy: configuration of the energy mode, developed for welding with energy control
supervised by a DMOS (see chapter «ENERGY MODE»).
: corresponds to the program recall modes window:
4
• JOB: create, save, delete and recall JOB.
• QUICKLOAD: JOB recall using the trigger when not welding.
SEMI-AUTOMATIC WELDING (MODE MIG / MAG) - GMAW
THE SETTINGS OF THE MIG / MAG PROCESS
Settings Designation
Torque
material/gas
Wire diameter
Welding process
ModulArc
(Arc Module)
Trigger behaviour
Tack welding mode
Settings
AUTOPULSE 320-T3
Adjustable settings Manual
- Fe Ar CO2 18%
- Al Mg 5 Ar 100%
- HARDFACE Metal
- etc
Ø 0.8 > Ø 1.2 mm
- Manual
- Dynamic STD
- Pulse
- Cold Pulse
OFF - ON
2T, 4T
Spot, Delay
Thickness
Speed
Current
Dynamic STD
Pulse
(Standard)
Choice of the material to be welded.
Synergic welding parameters
Choice of wire diameter
Enables or not the modulation of the welding
current (appearance of a TIG weld bead)
Choice of trigger welding management mode.
Choice of scoring mode
Choice of the main parameter to be displayed
(Thickness of the part to be welded, wire
speed, average welding current).
EN
1 2 3
Recommendations
31