Electrical Connection; Overheating Protection & Reset; Design And Function - Caso HW 400 Manual Del Usuario

12.6 Electrical connection

In order to ensure the safe and trouble-free operation of the device, the following instructions
must be observed for the electrical connection:
 Before connecting the device, compare the connection data (voltage and frequency) on
the rating plate with those of your electrical network. This data must agree in order that no
damages occur in the device. If in doubt, ask your qualified electrician.
 The electrical outlet must be protected by a 16A safety cut-out switch.
 The connection between the device and the electrical network may employ a 3 meter long
(max.) extension cable with a cross-section of 1.5 mm². The use of multiple plugs or gangs
is prohibited because of the danger of fire that is involved with this.
 Make sure that the power cable is undamaged and has not been installed under the ice
maker or over hot or sharp surfaces.
 The electrical safety of the device is only guaranteed if the device is connected to a
properly installed protective conductor system. Operations using an electrical outlet
without a protective conductor are prohibited. If in doubt, have the house installation
checked over by a qualified electrician.
The manufacturer cannot be made responsible for damages that are caused by a missing
or damaged protective conductor.
12.7 Overheating protection & reset
The appliance is equipped with an overheating protection
facility. If the temperature of the appliance exceeds the
critical limit the appliance shuts off further power supply for
Please use enclosed reset-key for the reset-button.

13 Design and Function

In this chapter, you'll find important information on the design and function of the device.
Caso Heißwasserbereiter HW 400
safety reasons.
Remove the water tank. You can
see the reset button.
By pressing the reset button (1)
the appliance can be reactivated.
Unplug the device before reset.
When the device is only producing
cold water please press reset
button.
26