Fagor FG051 Modo De Empleo página 19

the set temperature has been reached and then will cycle ON and OFF throughout cooking. This will ensure that
the Grill always maintains the selected temperature.
The preheat time will depend on the heat setting selected. If a high heat setting is selected, a longer preheat time
is required.
NOTE 2: When barbecuing on high heat settings, the Grill will generate smoke. Selecting a lower setting will reduce
smoke.
Adequate ventilation is recommended.
Care and Cleaning
Do not leave plastic utensils in contact with hotplate while cooking
Do not use sharp objects or cut food on top of the Grill
When cleaning the non-stick coating do not use metal or other abrasive scourers. After cleaning, dry the Grill
thoroughly with a soft cloth before storing. Always turn the power off and remove the plug from the power point
before cleaning.
Remove the control probe from the socket of the Grill.
Control probe
If cleaning is necessary, wipe over with a damp cloth.
Do not immerse the control probe in water or any other liquid.
Store the probe carefully in a safe place. Do not knock or drop it as this can damage the probe.
Hotplate and drip tray
The element in the hotplate is totally sealed,so it is safe to fully immerse in water. Wash the hotplate and drip tray
in
warm soapy water using a mild household detergent and a soft washing sponge. A bottle brush may be used to
clean between
the hotplate grill bars. The whole unit is immersible in water for easy cleaning with the probe removed.
Storage
Always dry the Grill before storing. Ensure the drip tray is correctly positioned.
Store the Grill on a flat surface on your bench top or cupboard.
Important : Before inserting control probe in probe socket, ensure the interior of the socket is fully dry. To do this,
wipe interior of socket with a dry cloth or shake out excess water vigorously.
TECHNICAL DESCRIPTION
-
Voltage : 230 V~
- Frequency : 50 / 60Hz
- Power : 2200 W
THE DEFECTS DUE TO FAILURE OF THE EQUIPMENT AND DAMAGES DUE TO ANY ACTION OR REPARIS
MADE BY ANY THIRD PARTY OR DUE TO THE INSTALLATION OF PARTS THAT ARE NOT ORIGINAL DO
NOT COVERED BY THE RESPONSIBILITY OF THE SUPLLIER.
REMOVAL OF APPLIANCES USED