Chain Saw Names And Terms - Remington 107624-02 Manual Del Proprietário

CHAIN SAW NAMES AND TERMS

Process of cutting a felled tree or log into
Bucking
lengths.
Block or wedge used to secure wood from
Chock
moving.
Process of cutting down a tree.
Felling
Final cut when felling a tree. Make this
Felling Cut
cut on opposite side of tree from notching cut.
Located at front of saw body.
Front Handle
Shield between front handle and
Front Hand Guard
guide bar. Protects left hand while using saw.
Metal bar that extends from saw body.
Guide Bar
The guide bar supports and guides chain.
Tip or end of guide bar.
Guide Bar Nose
Quick backward and upward motion of
Kickback
guide bar. Kickback may occur when tip of guide bar
touches an object while chain is moving. The guide
bar will kick up and back towards operator.
Process of cutting limb(s) from a felled tree.
Limbing
Chain that reduces chance of
Low-Kickback Chain
kickback as required by ANSI B175.1.
Stance used while making
Normal Cutting Position
bucking and felling cuts.
Notch cut in tree that directs fall of tree.
Notching Cut
System for oiling guide bar and chain.
Oiler Control
Chain saw without chain and guide
Power Head
bar. Also known as saw body.
Rapid pushback of chain
Pushback (Kickback, Pinch)
saw. Pushback may occur if chain along top of guide
bar is pinched, caught, or contacts a foreign object.
www.remingtonpowertools.com
Handle located at rear of saw body.
Rear Handle
Reduced Kickback Guide Bar
duces chance of kickback.
Chain that complies with ANSI
Replacement Chain
B175.1 when used with a specific saw. It may not meet
ANSI requirements when used with other saws.
Loop of chain having cutting
Saw Chain (Chain)
teeth for cutting wood. The motor drives chain. The
guide bar supports chain.
Spiked Bumper (Spike)
saw body beside guide bar. Keep spiked bumper in
contact with wood when felling or bucking. It helps
maintain position of saw while cutting.
Toothed wheel that drives chain.
Sprocket
Device that completes or interrupts electrical
Switch
circuit to motor of saw.
This device connects switch to trig-
Switch Linkage
ger. It moves switch when you squeeze trigger.
Device that reduces accidental
Switch Lockout
starting of saw.
Device that turns saw on and off. Squeezing
Trigger
trigger turns saw on. Releasing trigger turns saw off.
Process of cutting limb(s) from
Trimming (Pruning)
a living tree.
An upward cut from underside of log or
Undercut
limb. This is done while in normal cutting position
and cutting with top of guide bar.
8
Guide bar that re-
Pointed teeth at front of