Controls - Troy-Bilt Storm 2410 Manual Del Operador

Controls and Features
Chute Assembly
Chute Clean
Out Tool
Augers
Shift Lever
The shift lever is located in the right side of the
handle panel and is used to determine ground
speed and direction of travel.
Forward
Reverse
slower and two (2) is the faster.
Drive Control
Directional Control †
Shift Lever
Headlight †
Skid Shoe
Figure 4-1
Skid Shoes
Position the skid shoes based on surface conditions. Adjust
upward for hard-packed snow. Adjust downward when
operating on gravel or crushed rock surfaces. See Set-Up &
Assembly section. Skid shoe styles and appearance vary by
model.
Augers
When engaged, the augers rotate and draw snow into the auger
housing.
Chute Assembly
Snow drawn into the auger housing is discharged out the chute
assembly. Chute assembly styles and appearance vary by model.
Headlight
The headlight is located on top of the handle panel and is
automatically turned on when the engine is started.
4-Way/2-Way Chute
Auger Control
Heated Grips †
Standard Chute
Directional Control †
† If Equipped
(If so equipped)
4
13