Assembly & Set-Up - Troy-Bilt Storm 2410 Manual Del Operador

Assembly & Set-Up
Contents of Carton
One Snow Thrower
One Snow Thrower Operator's
Manual
One Engine Manual
Assembly
Handle
2. Observe the lower rear area of the snow thrower to be sure
both cables are aligned with roller guides before pivoting
Figure 3-1
NOTE: Make certain the cables are seated properly in the
roller guides. See Figure 3-2.
3. Secure the handle by tightening the plastic knob located
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
Two Replacement Auger Shear Pins
One Product Registration Card
Chute Assembly (Model 2410)
Position the chute assembly over the base. See Figure 3-3.
One Chute Assembly
One Chute Control Rod
Figure 3-2
Figure 3-3
3
7