Starting A Washing Programme; Wash Cycle Table; Turning On The Appliance; Change The Programme - CORBERO E-CLVG91520I Manual Del Usuario

6. Starting a Washing Programme

Wash cycle table

Cycle Selection
Program
Information
For the heaviest soiled loads,
such as pots, pans, casserole
dishes and dishes that have
been sitting with dried food
Intensive
on them for a while.
For normally soiled loads,
Eco
such as pots, plates, glasses
(*E 60436) N
and lightly soiled pans.
(Standard
standard daily cycle.
Programme)
Light wash cycle to be used
for more delicate items which
are sensitive to high
Light temperatures.(Run cycle
immediately after use)
For lightly soiled loads, such
as plates, glasses, bowls and
Crystal lightly soiled pans.
For lightly and normally soiled
plates and pans for every day.
60 min
A shorter wash for lightly
soiled loads that do not
Rapid
need drying.
To rinse dishes that you
plan to wash later that day
Pre-Rinse
EN60436: this program is the test cycle
The information for comparability test in accordance with EN60436, as follows:
- Capacity: 15 settings
- Position of upper basket: Low position
- Rinse aid setting: 6 ( or 4 for four setting dispenser)

Turning on the Appliance

Starting a wash cycle...
Draw out the lower and upper basket, load the dishes and
1. push them back. It is recommended to load the lower basket first, then the upper one (see the
section entitled "Loading the Dishwasher"). Pour in the detergent (see the section entitled "Salt,
Detergent and Rinse Aid").
16
Detergent Energy
Description Running
Pre/main (kWh)
of Cycle Time
(min)
Pre-wash
Main wash(60℃)
Rinse1
3/20g
213 1.680
Rinse2
(or 3 in 1)
Hot rinse
Drying
Pre-wash
Main wash(48℃) 3/20g
234 0.861 10.0
Hot rinse
(or 3 in 1)
Drying
Pre-wash
Main wash(45℃)
3/16g
Rinse
152 0.950
(or 3 in 1)
Hot rinse
Drying
Main wash (40 ℃ )
Rinse
3/16g
124 0.900
Hot rinse
Drying
Hot rinse1
Hot rinse2
3/16g
60 1.050
Hot rinse(50℃)
Drying
Main wash(45℃)
15g
40 0.600
Hot rinse
Pre-wash 12 0.010
2. Insert the plug into the socket. The power supply is 220-240V AC 50 Hz, the specification of the
socket is 12 A 250 VAC.50 Hz.
Make sure that the water supply is turned on to full pressure. Close the door, press the"Power"button,
Press the "Program" button to select a desired "Wash cycle". (See the section entitled "Wash
Cycle Table") . With a little force to ensure the door is properly closed.
Water
(L)
NOTE:
A click could be heard when the door is closed perfectly.
When the washing is over, you can shut off the switch by pressing"Power" button.

Change the Programme.

15.3
Premise: A cycle that is underway can only be modified if it has only been running for a short time.
Otherwise, the detergent may have already been released, and the appliance may have already
drained the wash water. If this is the case, the detergent dispenser must be refilled (see the section
entitled " Fill in the Detergent " ).
Press"Power" button to cancel the programme, and turn on it again ,then you can change the
programme to the desired cycle setting (see the section entitled "Starting a wash cycle. . . " ).
NOTE: If you open the door when washing, the machine pauses and warning alarm rings, the display
appears E1. When you close the door, the machine will keep on working .
13
The 6 programme lights show the state of the dishwasher:
a) One of the programme lights on--> cycle running
b) One of the programme lights blinking -->pause
11.0
NOTE:
If all the lights begin to glimmer, that indicates the machine is out of order, please turn off the
main power and water supply before calling a service.

Forget to Add Dish

9.6
A forgotten dish can be added any time before the detergent cup opens.
1 Open the door a little to stop the washing.
2 After the spray arms stop working, you can open the door completely.
6.6
3 Add forgotten dishes.
4 Close the door, the dishwasher will work after ten seconds.
3.9
WARNING!
It is dangerous to open the door when washing, because the hot water may scald you.
Switch Off the Dishwasher
The digital display appears "---" and the buzzer rings 6 times, only in this case the programme
has ended.
1.Switch off the dishwasher by pressing the"Power" button.
2.Turn off the water tap!
Open the door carefully. Hot steam may escape when the door is opened!
■Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down around
15 minutes before removing from the appliance.
■Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes. In
this way they will be cooler and the drying will be improved.
Unloading the dishwasher
It is normal that the dishwasher is wet inside.
Empty the lower basket first and then the upper one. This will avoid water dripping from the upper
basket onto the dishes in the lower one.
17