Philips Lumea Plus TT3003 Manual De Instrucciones página 16

ENGLISH
16
2 Press the on/off button to switch on the appliance.
Intensity light 1 goes on automatically to indicate that the appliance
,
is switched on at default intensity 1.
Note: It is normal that the appliance and the attachment become warm during
use.
3 Start each treatment by selecting the light intensity very carefully,
based on your skin's sensitivity and on how comfortable the
treatment feels.
Your skin may react differently on different days/occasions for a number of
reasons. See section 'Possible side effects and skin reactions' in this chapter
for more information.
4 Press the % button to increase the intensity. To lower the intensity,
press the ^ button.
Every time you press the button, the corresponding intensity
,
light starts to flash. This takes a few seconds.
5 Place the appliance at a 90° angle on the skin so that the body
attachment and the safety ring are in contact with the skin.
Note: It may be difficult to have the safety ring make proper contact with the
skin on certain areas. In that case, you could hold the Philips Lumea Plus for
men upside down, while you press the flash button with your thumb.
6 Press the safety ring fully onto the skin with slight pressure.