Philips Lumea Plus TT3003 Manual De Instrucciones página 27

Ocultar thumbs Ver también para Lumea Plus TT3003:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Problem
The treated areas
become red after the
treatment.
The skin reaction after
the treatment lasts longer
than usual.
The hair reduction results
are not satisfactory.
Hair starts to grow again
on some spots of the
treated areas.
Possible cause
Solution
Slight redness
No action required.
is harmless and
normal and
disappears quickly.
You have used
Select a lower light intensity the next time. See chapter
a light intensity
'Preparing for use', section 'Setting the light intensity.
which is too high
for you.
If the skin reaction lasts longer than 3 days,
contact your doctor.
You have used
Select a higher light intensity the next time.
a light intensity
which is too low
for you.
You did not make
For proper hair-removal results, you have to make
enough overlaps
overlaps when you use the appliance. See chapter
when you used
'Using the appliance', step 7.
the appliance.
You do not use
To remove all hairs successfully and prevent the hair
the appliance
follicle from becoming active again, the treatments have
as often as
to be repeated once every two weeks for the first
recommended.
two to three months. Your skin should be smooth by
then.To ensure that your skin stays smooth, we advise
you to repeat the treatment every four to six weeks.
The time between treatments may vary based on your
individual hair regrowth and also across different body
areas. If too many hairs grow back between treatments,
simply shorten the treatment interval again, but do not
treat any area more often than once every two weeks.
When you use the appliance more frequently than
recommended, you do not increase the effectiveness
but you do increase the risk of skin reactions.
The appliance is
Do not use the appliance if your body hair is light
not suitable for
blond, red, grey or white. Do not use the appliance
your hair or skin
either if you have very dark skin.
colour.
You did not make
For proper hair-removal results, you have to make
enough overlaps
overlaps when you use the appliance. See chapter
when you used
'Using the appliance', step 7.
the appliance.
Hair starts to grow
This is normal. It is part of the natural cycle of hair
again as part of
growth that hair starts growing again. The hairs that
the natural cycle of
come back, however, tend to be softer and thinner.
hair growth.
ENGLISH
27

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido