Moving The Machine; Installation; Notes On Installation - NAMCO MAZAN Manual Del Operador

4. MOVING THE MACHINE

l
This equipment is fitted with castors to make it easier to move. Take care when
moving the equipment on an inclined floor.
l
Ensure that the feet are raised clear of the floor before moving and re-lowered
when the equipment is in it's new position.
l
Ensure that the Front Assy is seperated from the Monitor Assy before moving
this equipment.
l
The overall height of this equipment is 2220mm. Take care of any overhead
obstructions. (e.g. Light Fittings, Electric Cables etc.)

5. INSTALLATION

5-1

Notes on Installation

WARNING
l l l l l
WARNING
l l l l l
WARNING
l l l l l
i
CAUTION
NOTE
• NEVER turn the power to the machine ON until installation
has been completed.
• In order to prevent possible electric shocks, be sure that the
machine is connected to the mains with a securely connected
earthed plug.
• So that customers are not injured , ensure that there is at
least 500mm separation between other machines or walls.
• In order to avoid damage to the machine due to mis-operation,
ensure that the voltage of the mains supply is 230volts AC.
• If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level adjusters
to prevent the machine sliding on the floor.
• In order to gain access to the rear of the Monitor, make sure that
the rear of the machine is separated from a wall or other machine
by at least 500mm.
Page 34