Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
4. MOVING THE MACHINE
This equipment is fitted with castors to make it easier to move. Take care when
moving the equipment on an inclined floor.
The overall height of this equipment is 1890mm. Take care of any overhead
obstructions. (e.g. Light Fittings, Electric Cables etc.)
When moving the equipment, ensure that the equipment is dis-assembled into
3 parts: Monitor Assy, Coin Tower Cabinet and Ride Assy.
5. INSTALLATION
Notes on Installation
WARNING
WARNING
WARNING
CAUTION
NOTE
•
NEVER turn the power to the machine ON until installation
has been completed.
•
In order to prevent possible electric shocks, be sure that the
machine is connected to the mains with a securely connected
earthed plug.
•
So that customers are not injured , ensure that there is at
least 500mm separation between other machines or walls.
•
In order to avoid damage to the machine due to mis-operation,
ensure that the voltage of the mains supply is 230volts AC.
•
If the location site of this machine has a polished floor it is
recommended that rubber pads are fitted under the level
adjusters to prevent the machine sliding on the floor.
•
In order to gain access to the Power Supply and CPU assembly,
make sure that the rear of the machine is separated from a wall
or other machine by at least 500mm.
•
When installation is complete, it is imperative that the game is
initialized.
(See section 7 page 50)
Page 31
Publicidad
Tabla de contenido
