Pro-Lift F-2525 Instrucciones De Funcionamiento Y Manual De Piezas página 3

PREPARATION
!
WARNING: Do not lift or carry jack by the Pump Handle. Pump Handle could dislodge and jack fall, resulting
in possible injury or property damage.
Before Use
1. Before using this product, read the operator's manual completely and familiarize yourself thoroughly with the
product and its components, and recognize the hazards associated with its use.
2. Verify that the product and application are compatible. If you have questions about the use of this jack or its compatibility
with your vehicle, call Customer Support (816) 891-6390.
3. To familiarize yourself with basic operation, use the stamped end of the provided handle to engage and turn the
release valve:
a. Clockwise until firm resistance is felt to further turning. This is the 'CLOSED' release valve position used to
raise the saddle.
b. Counter-clockwise, but no more than 1/2 turn from the closed position. This is the 'OPEN' release valve position
used to lower the saddle.
NOTICE: Use the handle provided with this jack. The provided handle will properly engage the release valve and
operate the handle sleeve. If the handle is worn, bent, operates abnormally, or will not positively engage the release
valve, discontinue use of the jack until a factory replacement handle can be acquired.
4. With saddle fully lowered and release valve closed, insert handle into handle sleeve and pump the handle. If lift
arm responds immediately, jack is ready for use. If jack does not respond, follow Bleeding/Venting Trapped
Air instruction below. Check oil level. Proper oil level will vary from just covering the ram cylinder to 3/16" above
it as seen from the oil filler hole. Reinstall oil plug.
5. Ensure that jack rolls freely. Raise and lower the unloaded saddle throughout the entire lifting range before putting
into service to ensure the pump operates smoothly. Replace worn or damaged parts and assemblies with genuine
factory replacement parts only.
Bleeding/Venting Trapped Air
With the release valve in the OPEN position (step 3b. above) and with saddle fully lowered, locate and remove the
cover plate, then remove the oil filler plug. Insert handle into handle sleeve and pump 6 to 8 full strokes. This will help
release pressurized air which may be trapped within the reservoir. Reinstall the oil filler plug and check operation.
Handle Sleeve
Release Valve
Rear Caster
Cover Plate
Oil Filler Plug
(ref. Parts illustration
for location)
Figure 1 - Typical Floor Jack Nomenclature
Lift Arm
Handle
3
Saddle
Front Wheel
Engage release
valve with this end