Dc Output Socket - Wagan Tech Power Dome LT Manual De Usuario

Power Dome™ LT by Wagan Tech
2. Prior to plugging in your device, turn your power tool or appliance off. Mobile devices are
fine to keep on, but operating them during the charging process will prolong charging time.
3. Open the AC outlet dust cover.
4. Connect the electrical plug of your device/appliance to the AC outlet.
5. Turn the Master Switch on.
6. Set the Inverter/USB Switch to the "||" position. Check for the indicator to be lit.
• After use, remove the device/appliance plug, close the dust cover, and turn the Inverter/
USB Switch off.
7. Turn the Master Switch off.
8. Recharge the Power Dome as soon as it is convenient.

DC OUTPUT SOCKET

The DC accessory socket can power a DC load up to 10 Amps. Overloading the socket will result
in tripping the self-resetting circuit breaker. Removing the overload automatically restores power
to the DC socket. For proper and safe operation of the 12 Volt DC power accessory sockets, do
not place anything in them except the 12V DC plug of the accessory to be used.
1. Check the required current draw of the appliance/device to be powered and make sure it
does not exceed the Power Dome's maximum wattage.
2. Remove the dust cover from the DC socket.
3. Insert the 12V DC plug of your device/appliance(s) into either of the Power Dome's
DC socket(s).
4. Turn the Master Switch on.
5. Operate your device/appliance as usual.
6. After use, remove the device/appliance's plug(s), close the dust cover(s), and turn the Master
Switch off.
7. Recharge the Power Dome as soon as convenient.
14
®
www.wagan.com