Wall Inlet Installation - NuTone PUREPOWER Serie Manual De Instalación

INSTALLATION IN NEW CONSTRUCTION (

WALL INLET INSTALLATION

MODEL 360 W I
ALL NLET
(CF361 CF361F R
AND
B
Remove the cardboard plaster guard.
C Refer to figure at
For some drywall or panel
construction, the plaster frame
will extend beyond the finished
wall. In this case, remove
plaster frame from mounting
bracket by removing mounting
screws.
NOTE: When using the model CF361 and CF361F inlet
bracket on walls thinner than 1⁄2", use a 1⁄4" spacer
(not furnished) between the wall and the inlet bracket.
See figure below. Spacer may be made from plywood,
Masonite™, etc. Contact cement may be used to hold
spacer in place during assembly. Configuration of
spacer may vary depending upon installation.
INLET MOUNTING
1/4"
BRACKET
3
1
2 / "
4
AD0057A
D Refer to figure at right.
Connect 2-conductor low-
voltage wire to terminal
screws on back of wall inlet.
E Guide excess wire back through the hole in inlet bracket and
flanged fitting.
F Refer to figure at right. Place
inlet into mounting bracket and
secure.
- )
OUGH INS
right.
AR0045
SPACER
WALL LESS THAN
1
/ " THICK.
2
1
PLASTER
/ "
4
GUARD
HOLE
AE0040
INLET
AE0024A
NOTE: When wall inlets are installed in walls that are less than
1⁄2" thick or when inlets are installed back-to-back in
a wall, the tube of the wall inlet may extend into elbow
area of the flanged fitting and cause blockage. Shorten
the wall inlet tube to prevent this condition. Refer to
figure below.
WALL
AD0058A
For extra thick walls, use Model 399 Extension Sleeve
to connect inlet to the flanged fitting.
MODEL 330 W
B Refer to figure at right. Connect
2-conductor low-voltage wire
to terminal screws on back of
wall inlet.
C Align inlet mounting holes with
holes in mounting plate.
D
Refer to figure at right. Place
inlet into mounting plate and
secure with
screws.
MOUNTING
PLATE
9
' )
CONT D
MODEL CF365
DOUBLE FLANGED
TEE
SHORTEN
MOUNTING
BRACKET
I (CF329 R
ALL NLET
INLET
two provided
AE0024A
WALL
INLET
- )
OUGH IN
MOUNTING
PLATE