BOB BLAZE Guia Del Usuario página 9

4� Insert Through Axle
Insert the through axle into the
fork and through the wheel hub,
then install the tension adjusting
nut to the opposite side.
5� Tighten Tension Adjusting Nut
With the quick release lever in
the FULLY OPEN position, hand
tighten the tension adjusting nut
until secure.
Tension Adjusting Nut
6� Close Quick Release Lever
Lift up on the quick release lever
to lock into the FULLY CLOSED
position. When properly closed,
the quick release lever will be
parallel to the fork blade and
pointing up.
FULLY CLOSED
FULLY OPEN
IMPORTANT:
considerable force to securely
close the quick release lever. If
you are able to completely close
the quick release lever without
wrapping your fingers around the
fork blade and the quick release
Fork Blade
It takes
lever does not leave a visible
imprint in the palm of your hand,
or the quick release lever spins
freely on the through axle, the
tension is not adequate. Return
the lever to the FULLY OPEN
position and turn the tension
adjusting nut a quarter turn
clockwise, then repeat the closing
process.
If the quick release lever will
not lift into the FULLY CLOSED
position, return the lever to the
FULLY OPEN position and turn
the tension adjusting nut a quarter
turn counterclockwise. Repeat the
closing process.
7� Close Brake Quick Release
After installing the front wheel,
the brake release will need to be
placed in the closed position.
Close the brake release lever by
squeezing the brake pads toward
the wheel with either hand then
rotate the brake release lever with
your other hand, in the counter
clockwise direction, until it points
downward.
Brake Quick Release
Check the front wheel before
each use of the stroller to
ensure it is properly secured�
Failure to secure the front
wheel can cause the wheel to
vibrate, wobble, or become
detached from the stroller�
FALL HAZARD - Wheel can
detach and cause tip over� Pull
on the wheel to assure it is
securely attached�
BLAZE User Guide
CLOSED
7