Assembly; Start Up - Truper CEPEL-4-1/2NX Manual Del Usuario

Assembly

Blades Set Up
1. To remove the blades, loosen the screws and lift the blades as shown
in the figure 1.
2. Slide the blade trough the support block in the cutter head as shown
in the figure 2.
3. Tighten evenly the three adjusting screws. Remember, a loose screw
can be extremely dangerous. Double-check regularly for tightness.
4. Repeat the same procedure with the second blade.
Before setting up the blades, turn off and disconnect
CAUTION
the tool. Remove all shavings or any debris from the cutter head. Use
clean blades having the same dimension and weight. Otherwise the
cutter head will oscillate and shake making a deficient planning or
causing the machine to break.
The blades are sharp on both sides. If one side gets dull or wears out,
turn it around and use the second sharp side. When both sides are dull,
replace blades, do not try to sharpen the blades.
When replacing blades, change both blades simultaneously. Otherwise
the vibrations produced shorten the useful life of the blades and tool.
5. Blades shall be adjusted so that the cutting edge is level to the fixed
base height.
Parallel Guide Set Up
1

Start Up

Start and Operation Control
• Connect the plug into the power outlet.
• Keep the switch lock (B) pressed to unblock the switch (A). The switch
lock prevents from accidentally starting up the tool.
• Press the switch (A) to start the cutter head in motion.
• To stop the cutter head, release the switch (A).
Cutting Depth Adjustment
• To make the adjustable base reach the desired height, turn the cutting
depth-adjusting knob until the measure in millimeters indicated in the
knob's graded ring matches the triangular mark.
• To determine precise cutting depths, plan a piece of scrap wood, measure
the thickness difference and adjust to the needed value.
2
B
A
Triangular
ENGLISH
1
2
Cutting
depth
adjusting
knob
Graded
Ring
Mark
7